JOURNAL OF PROSTHETIC DENTISTRY THE

Vol. 102 No. 3      September - 2009

ISSN: 0022-3913      UBIC: 171

RESUMEN

Statement of problem. Remelting previously cast metal can produce a critical change in metal-oxide composition at the dental alloy surface. Purpose. The purpose of this study was to evaluate the effect of multiple castings on bonding of a single selected base metal and a dental ceramic, arid to compare results from shear bond and 3-point-bending tests. Material and methods. Three groups of dental alloy (Remanium CSe) were prepared by mixing 50% fresh alloy to alloy remnants from previous castings. The specimens in the first casting group used 100% fresh alloy and served as control (C0). The second group consisted of equal amounts of fresh alloy and alloy remnants cast only once (C1). The third and fourth groups contained 50% fresh alloy and alloy cast twice (C2) and 3 times (C3), respectively. The bond load (N) between alloy and dental porcelain (VMK 95 Metal Ceramic) was evaluated, using shear bond and 3-point- bending tests. The fracture surfaces of the specimens subjected to testing were analyzed using a stereomicroscope and scanning electron microscope. One-way ANOVA followed by the Tukey multiple comparison test was used for analysis of bond data (α=.01). Results. The mean shear bond load (SD) of CO (738.0 (77.1) N) was significantly higher than that of C1 (577.8 (139.4) N), C2 (494.8 (77.6) N), and C3 (480.5 (60.9) N). Mean peak load for the 3-point-bendingtestofspecimens cast from CO (39.8 (1.79) N) was significantly higher than for other groups (P<.01). No significant difference was found between C1(24.4 (5.60) N), C2 (23.2 (4.03) N), and C3 (22.8 (1.79) N) in terms of the shear bond test and the 3-point bending test. Conclusions. In general, there was agreement between the 2 bond strength tests to indicate that including recast base alloy with fresh alloy for metal decreases metal-to-ceramic bond strengths. (j Prosthet Dent2009;102:165-171)

| Volver |